| no tools needed |
| from rafterydesign,inc. | ||
|
|
The Edgewing can be re-mounted with most ½” wide, double-faced foam tape products, available at all hardware or drug stores.
Step 1: Clean surface where Edgewing is to be installed.
Step 2: Peel protective paper strip from tape.
Step 3: Push Edgewing tightly against edge of work surface.
Step 4: Press down above tape location to insure good adhesion.
Step 1: Remove Edgewing by holding rear corner and peeling upwards toward center.
Step 2: After Edgewing has been removed, using thumb, gradually rub remaining tape and glue from both surfaces.
Step 3: Locate extra tape strip under Edgewing and apply it to “lip” location.
Step 4: Follow initial steps 1 thru 4 of the installation instructions.